Large Fiberglass Halloween Pumpkin Sculpture for Mall & Park Display

individual · Original cartoon pumpkin, seasonal public display · City park plaza, Copenhagen, Denmark

A Halloween figure in a public space has to be spooky without being frightening, and cartoon without looking cheap.

The brief

A city parks department wanted a Halloween marker for a plaza that doubles as a trick-or-treat route: one figure, 2.2 m, cartoon-proportioned, in a public space where children run past it every evening for three weeks. The reference was a jack-o-lantern, but abstracted — no carved face that could be read as a person, no sharp edges, nothing that would look out of place in daylight in November.

No sharp edges in a public square

Everything on the figure is rounded: the ribs are shallow moulded channels, not cut lines; the stem is a single cast piece with a domed top; the base sits flush with the paving so nobody can catch a foot on it. The shell is FRP fibreglass, hand-laminated, under 200 kg, on a 100 mm cast pad. It needs no power and no fixings beyond four anchors, so the parks crew can install it themselves.

Orange that survives daylight

A gloss orange pumpkin reads as a toy in sunlight, and a matte one reads as dirty. The finish here is a satin pumpkin-orange with the ribs picked out in a slightly deeper tone, plus a black base and a matte black stem. The colour holds under flat autumn light and under street lighting at night, and the surface resists graffiti remover and the wrong kind of brush.

Three weeks up, three weeks down

The figure lifts off its base in one piece and packs into a 1.3 m flight case. The base stays in the ground all year, so reinstalling next October is four anchors and one lift. The handover includes the anchor pattern, the lifting boss position, and a single care sheet — because a seasonal piece that depends on the original installer is a seasonal piece that never comes back.

A public-space Halloween figure has to be cartoon enough for children, robust enough for a plaza, and simple enough for the parks crew to put up and take down without a structural engineer every time.

FRP fibreglass, hand-laminated hollow shell with moulded lifting bosses Material
Satin pumpkin-orange with deeper rib tones, matte black base and stem Finish
2.2 m tallest, 1.4 m wide at base, under 200 kg complete Size
Public plaza and trick-or-treat route Placement
8 weeks from 3D approval Lead time
2026 Completed

Commission a Piece Like This

Get a Free Quote